Precautions when using Paraffin forming machine
The paraffin molding machine must run forward; avoid reverse rotation. It is forbidden to run the machine with no load, and the machine must be heated and run with materials, so as to avoid the phenomenon of rod sticking (shaft holding). It is strictly forbidden to enter iron or other debris into the feed port and vent hole of the paraffin molding machine. To avoid causing accidents and affecting normal production. The following will introduce you to the precautions when using the paraffin molding machine.
1. Before turning on the machine, let it warm up for about forty or fifty minutes. Raise the temperature until the motor V-belt is pulled freely by hand; pull it continuously eight to ten times in the normal working direction. Then continue to heat up for about ten minutes, and then turn on the machine, but continue to heat up, because normal production requires continuous replenishment of heat, and different temperatures are adjusted according to different properties.
2. When the paraffin wax molding machine is working normally, the machine temperature should be kept stable and should not fluctuate high and low. The temperature near the vent hole and up to the machine head should be maintained at about 200°C (referring to materials C and B).
3. The feeding of materials should be even and there should be no shortage of materials. The machine's feeding speed and feeding speed must be properly matched. Otherwise, the quality and yield of pellets will be affected.
4. Pay attention to the temperature changes of the machine at any time. When touching the sliver with clean hands and it does not stick to your hands, the temperature should be raised immediately. It is normal until the sliver touches your hand.
5. When the bearing part of the reducer burns or is accompanied by noise, it should be stopped for timely inspection and refueling.
6. When the bearing parts at both ends of the main bearing chamber are hot or make noise, stop the machine for maintenance and add butter. During normal operation, the bearing chamber is filled with butter every 5-6 days.
7. Pay attention to the operating rules of the machine; such as: machine temperature, speed, and speed, and handle them in time according to the situation.
8. When the fuselage is running unstable, you should check whether the coupling gap is too tight and loosen it in time.
9. When shutting down, the host must cut off the power supply. The machine head screw plug (the part with the wrench) needs to be removed. Preheat separately before next use.
