Causes of clogging of Paraffin forming machine
The seven-sided roller of the Paraffin forming machine is easy to disassemble and clean. The mechanical transmission system is completely enclosed in the body and is equipped with a lubrication system. The whole machine operates smoothly. However, in actual use, blockage will always occur. This is It affects normal work, and the reason needs to be found.
Reasons for blockage of paraffin molding machine:
1. Paraffin wax molding machine, etc. The ideal production conditions of the paraffin molding machine during the production process are: appropriate moisture content of the raw materials, good steam quality, and sufficient conditioning time. The correct use of dry saturated steam for molding can greatly improve the output of the paraffin wax molding machine and the quality of the pellets. To achieve good particle quality and high output, in addition to the normal operation of each transmission part of the paraffin wax molding machine, the quality of dry saturated steam entering the conditioner of the paraffin wax molding machine should also be maintained.
2. The gap between the die rollers is too large, causing the material layer between the die rollers to be too thick and unevenly distributed, and the pressure rollers to be unevenly stressed and prone to slipping. Once the squeezing force of the die roller on the material is less than the resistance of the inner wall of the die hole on the material, the material cannot be squeezed out and the machine will become blocked.
3. The pellet feed must meet the competitive needs of the market and be of high quality. The conditioning effect of the material before molding is crucial because it directly affects the output and particle quality of the paraffin wax molding machine. In particular, the water stability of special aquatic products is an important indicator.
